Monoblock directional control valve Galtech Q45 60l/min 12 v 5 sections 

Max flow: 60 l/min 

Solenoids:  12V

Valve type GALTECHQ45

Magnet connection Type DIN 43650 (vers. A)

Protection type IP65

Coil insulation class H Supply voltage 12V D.C./12V D.C.

Maximum voltage tolerance ±10%

Absorbed power supply 58W

Maximum utilization ratio 100%

Directional control valve characteristics (60 l/min)

Max. working pressure 275 bar (3988 PSI)

Max. back outlet pressure 25 bar (3363 PSI)

Emergency operation or in case of power failure With lever

Max. spool leakage of A and B ports to T port at 1450 PSI with viscosity 35 mm2/s 5 cm3/minIt is widely used in hydraulic systems in construction, agriculture and industry.

The valve is adapted to various types of machines such as: agricultural machines, tractors, cyclops, sprayers, turners, HDS loaders, construction machines, loaders, excavators, sweepers, industrial machinery and other hydraulically operated equipment.

Ideally suited for machines and vehicles where the ability to control the distributor is required from two places, e.g. electrically from the cab and with levers while standing directly at the distributor, This is the case, for example, with HDS and cranes.

Cylinder Spool type, for request we can build valve with ''D spool'' motor type.

The Powerbeyond bushing is a device that allows the activation of an additional flow-limited valve downstream of another valve, by changing the function of the 'T' port to a pressure port. This solution provides power to the downstream valve from the port normally intended for the 'tank', allowing the transfer of high pressure. To use this functionality, it is also necessary to remove the cap from the top of the valve block, allowing it to be used as a reservoir connection.