Both sliders on the sections three-position on the spring, that is, they return to the neutral position by themselves.

Internal threads in the body:

Connection port supply: 1/2'' BSP

Connection port return : 3/4'' BSP

Section connection ports : 1/2'' BSP

Cable connections:

Tube internal thread: M16x1.5

Internal threads of the slide end: M6x1.5

Pressure range:

Maximum supply pressure: 250 Bar (3625.94 psi)

Maximum pressure on return: 50 Bar (725.19 psi)

Maximum pressure on sections: 300 Bar (4351.13 psi)

The opening pressure of the bypass valve increases proportionally with increasing flow rate:

180 bar (2610.68 psi) at 20 l/min (5.28 gallon/min)

190 bar (2755.72 psi) at 40 l/min (10.57 gallon/min)

200 bar (2900.75 psi) at 60 l/min (15.85 gallon/min)

210 bar (3045.79 psi) at 80 l/min (21.13 gallon/min)

Temperature range and oil type: 

Permissible ambient temperature: -40°C to +60°C

Permissible oil temperature: -15°C to +80°C

Recommended hydraulic oil on mineral oil basis, e.g. HL 32 or HL 46

Recommended oil filtration of 10 - 15 µ

Open centre system (pump-to-tank flow)

Modification / Spools with 1 to 7

HIGH QUALITY Made in EU

Dimensions:

Joystick with 1 push-button:

Max. cable stroke: 14+14 mm

Lever ratio: 6,5:1

Cross-type movement

Cable type: standard

Lateral safety lock

Operating temperature: -30°C ÷ +80°C

Lubrication: Molikote g72

Cable for Joystick: 

Max. cable stroke: 30±2 mm

Disconnection load of wire rope terminal: 3000 N

Disconnection load of conduit terminal: 3000 N

Min. bending radius: 200 mm

Operating temperature: -30°C ÷ +80°C

IB-431216

Choice of metal or plastic ball.

We also have other line lengths available if you need it. Please let us know.

1.0m - 39.37''

1.5m -59.06''

2.5m - 98.4''

3.0m - 118.11''

The Powerbeyond sleeve is a device that allows an additional manifold to be connected by using a pressure transfer port.

This solution provides power to another valve from a normally closed port allowing high pressure to be transmitted.

To use this function, it is necessary to remove the plug from the pressure transfer port and screw the pressure transfer sleeve in place.