Scanreco RC400 Radio Remote Control Systems.

The Scanreco RC 400 G2B remote control system has been especially developed for

hydraulically driven mobile cranes and machinery. The system is a digital remote

control system based on an extremely advanced microprocessor technology. Years of

exhaustive and demanding testing have shown that the remote control system can

cope with the roughest of environments.

The system is protected against electromagnetic and radio frequency radiation and

can be installed onto all hydraulic valve types (voltage, current pulse width, or

protocol steered) found on the market.

In its basic form the remote control system is comprised of a portable control unit

with manoeuvre levers for proportional control and switches for ON/OFF functions, a

central unit with connection cable for driving proportional electro-hydraulic slide

controllers.

Digitally coded control information (lever deflection and switch position) is sent from

the portable control unit via radio to the central unit. The portable control unit and

central unit translate the magnitude and direction of the manoeuvre lever deflections

and switch position.

It can be used for four typical proportional functions, e.g.

-Slewing (rotation of crane)

-Main lift

-Jib

-Extension

-Grab open / close

-Rotator

You can also choose a different function as below:

Scanreco G2B Mini with 6 levers

- 1-6 linear levers

- Stop function according to EN ISO 13849-1 Cat. 3, PL e

- Various toggle switches, buttons and rotary switches

- Frequency bands: 433-434 or 902-928MHz (other frequencies available on request)

- Operating range > 100 m / > ~330 ft.

- Degree of protection: IP65

- Operating temperature: -20°C to +70°C / ~-4°F to +160°F

- Cable control: standard length 10 meters / ~33 ft.

- G2B Receiver PVG32 Danfoss 12 or 24 VDC power supply

- 8 bi-directional proportional outputs

- Choice of radio or cable control

- All analog outputs are programmable for final setting of speeds

- 14 digital outputs (where 1 is combined input/output) and 4 digital inputs (where 1 is combined input/output)

- A DV output to control the dump valve

- Radio communication in the ISM band using frequency hopping technology

- Manual mode available to bypass the radio system, providing only the DV output and allowing manual control via the hydraulic manifold (where available).

- Programmable logic with block, soak, decelerate, ramp functions and much more

- Please note that cable sets or connection plug sets are NOT included in the scope of delivery and must be ordered separately if required.

- Dimensions: (W x H x D): 350 x 160 x 190 mm / ~13.78 x 6.30 x 7.48 inches (without color display)

The kit works with a lot of application. For sure please contact with us.