Directional Control Valve 6-spool 50 L/Min 13GPM 12VDC + Control Panel 

All three-position sliders on a spring, i.e. they return by themselves to the neutral position when the power supply is cut. 

Slider principle:

Position 1 neutral (power supply cut off) cylinder piston rod stalls - oil goes to overflow.

Position 2 operational (power supply to solenoid one only) cylinder piston rod extends.

Position 3 operating (power supply to solenoid two only) cylinder piston rod retracts.

Internal threads in the body:

Connection port supply: 1/2'' BSP

Connection port return: 1/2'' BSP

Connection port sections : 3/8'' BSP

Pressure range:

Maximum supply pressure: 250 Bar (3625.94 psi)

Maximum pressure on return: 50 Bar (725.19 psi)

Maximum pressure on sections: 300 Bar (4351.13 psi)

The opening pressure of the bypass valve increases proportionally with increasing flow rate:

180 bar (2610.68 psi) at 10 l/min

190 bar (2755.72 psi) at 20 l/min

200 bar (2900.75 psi) at 30 l/min

210 bar (3045.79 psi) at 40 l/min

It is recommended to check and set the correct pressure before commissioning.

Self-adjustable, full rotation 30 Bar (435.11 psi change).

Temperature range and oil type: 

Permissible ambient temperature: -40°C to +60°C

Permissible oil temperature: -15°C to +80°C

Recommended hydraulic oil on mineral oil basis, e.g. HL 32 or HL 46

Recommended oil filtration of 10 - 15 µ

Open centre system (pump-to-tank flow)

Modification / Spools with 1 to 7

HIGH QUALITY Made in EU

The hydraulic valve is widely used in hydraulic systems in construction, industry and agriculture.

The valve is adapted to various types of machines such as: 

sprayers, turners, cyclops, HDS loaders, construction machines, loaders, excavators, sweepers, agricultural machines, tractors, industrial machines and other hydraulically operated equipment.

Can be used with MF, CASE, Caterpillar, Komatsu, Volvo, JCB, Liebherr, Hyundai, Bobcat, Kawasaki, John Deere..... and many more.

Scheme:

The Powerbeyond sleeve is a device that allows an additional manifold to be connected by using a pressure transfer port.

This solution provides power to another valve from a normally closed port allowing high pressure to be transmitted.

To use this function, it is necessary to remove the plug from the pressure transfer port and screw the pressure transfer sleeve in place.

Control panel for the Hydraulic Valves.

All up-down switches with automatic centring (1-0-2) with no latching.

Each panel is sold complete with a 2m power cable with plug, and a set of 4m cables each with plugs for the distributors. We also have extension cable sets of 3m, 5m or 9m.

In the switched position of any of the switches, the signal is also applied simultaneously to an additional pair of wires, which can be used to activate warning signals (horn, cockerel), or to switch on the pump via a relay.

All the panels offered, by default, are equipped with pushbuttons with positioning spring-loaded, which automatically return to the neutral position.

Include all plugs.

Power cable 2 meters and from panel to valve 3 meters.

Control of e.g. such 6-section directional valves.

Can be used with MF, CASE, Caterpillar, Komatsu, Volvo, JCB, Liebherr, Hyundai, Bobcat, Kawasaki, John Deere..... and many more.