Electronic Control Units CED 400W 400WCAN 12 Proportional Outputs

The CED400W is a microprocessor-based PWM driver designed to control 8 proportional solenoid valves (4+4).

In the controllers is always loaded the standard application software that is “ready-to-use” (e.g. for analog joysticks, CAN bus joysticks of fan drive) and the control parameters can be easily adjusted through the WST STUDIO software.

It is possible to develop and download a custom application software with the PHC Studtio tool. In this case access to IEC61131-3 programming language is built-in.

Also available is the PHC STUDIO Starter Kit (p/n 182400021), that contains an ECU, sample actuators, a wire harness, tutorial programs and the complete documentation.

Other features:

Solenoid currents measurement (to compensate changes in coil resistance, temperature and supply voltage)

- Programmable Dither frequency (to reduce spool sticking)

- Protected power supply (against reversed polarity and load dump)

- Protected inputs (against short circuits to GND and to power supply)

- Protected outputs (against short circuits, reversed polarity, over-current and over-temperature)

- Programmable according to IEC 61131-3 standard through PHC Studio

- 12/24 VDC applications

- Designed for PHC electronic systems

- 3 Hardware configurations with “ready-to-use” application software

Technical data:

Dimensions and pin-out:

Analog circuit configurations, you can find in the pdf.